The Range Is Not level.
Place the oven rack in the center of the oven.
The appliance has been installed improperly.
The Range Is Not level.
Contact a carpenter to correct the situation.
The floor is sagging or sloping.
The Range Is Not level.
Insure the cabinets are square and provide sufficient room for installation.
The kitchen cabinets are not properly aligned and make the range appear to be not level.
The Appliance Must Be Accessed for Servicing and Cannot Be Moved easily.
Contact a builder or installer to make the appliance accessible.
The kitchen cabinets are not square and too close to the appliance.
The Appliance Must Be Accessed for Servicing and Cannot Be Moved easily.
Provide sufficient space so the range can be lifted over the carpet.
Carpet is interfering with movement of the range.
The Display Goes blank.
Replace the fuse or reset the circuit breaker.
A fuse in your home may be blown or the circuit breaker tripped.
The Display flashes.
Reset the clock.
There was a power failure.
The Surface Units Will Not Maintain a Rolling Boil or Will Not Cook Fast enough.
Use pans which are flat and match the diameter of the surface unit selected.
You may be using inappropriate cookware.
The Surface Units Will Not Maintain a Rolling Boil or Will Not Cook Fast enough.
Cover the pan with a lid until the desired heat is obtained.
In some areas, the power (voltage) may be low.
The Surface Units Will Not Turn on.
Replace the fuse or reset the circuit breaker.
A fuse in your home may be blown or a circuit breaker may have tripped.
The Surface Units Will Not Turn on.
Check if the correct control is set for the surface unit you are using.
The cooktop controls are set improperly.
Areas of Discoloration on the cooktop.
Refer to the section on the care and cleaning of the glass cooktop on page 49.
Food spillover was not cleaned.
Areas of Discoloration on the cooktop.
This is normal.
The surface is hot and the model features a light-colored cooktop.
The Surface Unit Frequently Cycles on and off.
This is normal operation, and not a system failure.
The element will cycle on and off to maintain the power setting.
The Surface Unit Stops Glowing When Changed to a Lower setting.
n and hot.
This is normal.
Scratches or Abrasions on the Cooktop surface.
Scratches are not removable.
The cooktop is being cleaned improperly.
Scratches or Abrasions on the Cooktop surface.
To avoid scratches, follow the recommended cleaning procedures.
Cookware with rough bottoms was used on the cooktop or there were coarse particles (eg.
Scratches or Abrasions on the Cooktop surface.
To avoid scratches, follow the recommended cleaning procedures.
Cookware has been slid across the cooktop surface.
Brown Streaks or specks.
Wait until the surface cools down.
Boilovers have been cooked onto the surface.
Areas of Discoloration with Metallic sheen.
Remove using a ceramic- glass cooktop cleaning cream.
Mineral deposits from water and food have been left on the surface of the cooktop.
"Cracking" or "popping" sound.
This is normal operation, and not a system failure.
This is the sound of the metal heating and cooling during both the cooking and self- cleaning functions.
The Oven Will Not Turn on.
Make sure the electrical plug is inserted into a live, properly grounded outlet.
The range is not completely plugged into the electrical outlet.
The Oven Will Not Turn on.
Replace the fuse or reset the circuit breaker.
A fuse in your home may be blown or a circuit breaker may have tripped.
The Oven Will Not Turn on.
See the chapter on operating the oven starting on page 31.
The oven controls have been set improperly.
The Oven Will Not Turn on.
Allow the oven to cool.
The oven is too hot.
The Oven Will Not Turn on.
Call for service.
Incomplete service wiring. · Service usually needed
The Oven Will Not Turn on.
Check to see if the house lights will turn on.
Power outage. · Service usually needed
The Oven Light Will Not Turn on.
Tighten or replace the bulb.
The light bulb is loose or defective.
The Oven Light Will Not Turn on.
Call for service.
The switch operating the light is broken. · Service usually needed
The Appliance Will Not Turn on.
Make sure the power cord is plugged into a live, properly grounded outlet.
The appliance is not completely plugged into the electrical outlet or a fuse in your home may be blown or a circuit breaker may have tripped.
The Appliance Will Not Turn on.
Call for service.
Incomplete service wiring. · Service usually needed
The Appliance Will Not Turn on.
Check to see if the house lights will turn on.
Power outage. · Service usually needed
The Oven Smokes Excessively During broiling.
Refer to the section on using the broiler starting on page 38.
The oven controls have not been set properly.
The Oven Smokes Excessively During broiling.
Reposition the rack to provide proper clearance between the meat and the element.
The meat has been placed too close to the element.
The Oven Smokes Excessively During broiling.
Remove the excess fat from the meat.
The meat has not been properly prepared.
The Oven Smokes Excessively During broiling.
Regular cleaning is necessary when broiling frequently.
Grease has built up on oven surfaces.
Food Does Not Bake or Roast properly.
See the chapter on operating the oven starting on page 31.
The oven controls have not been set correctly.
Food Does Not Bake or Roast properly.
See the chapter on operating the oven starting on page 31.
The oven rack has been positioned incorrectly or is not level.
Food Does Not Bake or Roast properly.
See the section on using the oven racks on page 34.
Incorrect cookware or cookware of improper size is being used.
Food Does Not Bake or Roast properly.
See the section on adjusting the thermostat on page 42.
The oven sensor needs to be adjusted.
Food Does Not Broil properly.
Refer to the cooking guide for serving sizes on page 38, and then try again.
The serving size may not be appropriate.
Food Does Not Broil properly.
See the broiling recommendation guide on page 38.
The rack has not been properly positioned.
Food Does Not Broil properly.
Use suitable cookware.
The cookware is not suited for broiling.
Food Does Not Broil properly.
Preheat the broil element for 10 minutes.
In some areas, the power (voltage) may be low.
The Oven Temperature Is Too Hot or Too cold.
See the section on adjusting the thermostat on page 42.
The oven sensor needs to be adjusted.
The Oven Will Not Self-clean.
Allow the range to cool and then reset the controls.
The oven temperature is too high to start a self-clean operation.
The Oven Will Not Self-clean.
See the section on self- cleaning on page 45.
The oven controls have been set incorrectly.
The Oven Will Not Self-clean.
Deactivate the oven lockout (see page 43).
A self-cleaning cycle cannot be started if the oven lockout feature has been activated or if a radiant surface element is on.
Excessive Smoking During a Self-Cleaning cycle.
Press OFF.
There is excessive soiling in the oven.
The Oven Door Will Not Open After a Self- Cleaning cycle.
Allow the oven to cool.
The oven is too hot.
The Oven Is Not Clean After a Self-Cleaning cycle.
See the section on self- cleaning on page 45.
The oven controls were not set correctly.
The Oven Is Not Clean After a Self-Cleaning cycle.
Wipe up heavy spillovers before starting the self- cleaning cycle.
The oven was heavily soiled.
Steam Is Coming Out of the vent.
This is normal operation and not a system failure.
When using the convection feature, it is normal to see steam coming out of the oven vent.
Steam Is Coming Out of the vent.
This is normal operation and not a system failure.
As the number of racks or amount of food being cooked increases, the amount of visible steam will increase.
A Burning or Oily Odor Is Coming From the vent.
To speed the process, set a self-cleaning cycle for a minimum of 3 hours.
This is normal in a new oven and will disappear in time.
Strong odor.
Operate the oven empty on the bake setting at 400 °F for 1 hour.
An odor coming from the insulation around the inside of the oven is normal for the first few times the oven is used.
Fan noise.
This is not a system failure but normal operation.
A convection fan may automatically turn on and off.
Oven Racks Are Difficult to slide.
Apply a small amount of vegetable oil to a paper towel, and then wipe the edges of the oven racks with the paper towel.
The shiny, silver-colored racks were cleaned in a self- cleaning cycle.
The Drawer Does Not Slide Smoothly or drags.
Fully extend the drawer and push it all the way in.
The drawer is out of alignment.
The Drawer Does Not Slide Smoothly or drags.
Reduce weight.
The drawer is over-loaded or the load is unbalanced.
The Warning Drawer Will Not work.
Replace the fuse or reset the circuit breaker.
A fuse in your home may be blown or a circuit breaker may have tripped.
The Warning Drawer Will Not work.
See the chapter on using the warning drawer on page 44.
The controls are not set correctly.
Excessive Condensation in the drawer.
Remove the liquid.
There is liquid present in the drawer.
Excessive Condensation in the drawer.
Cover food with a lid.
Uncovered foods.
Excessive Condensation in the drawer.
Adjust the temperature to a lower setting.
The temperature is set too high.
Food Dries Out in the Warning drawer.
Cover food with a lid.
Moisture is escaping.
Food Dries Out in the Warning drawer.
Push the drawer in until the latch engages.
The drawer is not fully closed.
COOKTOP
Reset the clock.
There was a power failure.
The Surface Unit Stops Glowing When Changed to a Lower setting.
This is normal operation, and not a system failure.
This is normal.
Food Does Not Bake or Roast properly.
See the section on using the oven racks on page 34.
The oven rack has been positioned incorrectly or is not level.
Food Does Not Broil properly.
Preheat the broil element for 10 minutes.
In some areas, the power (voltage) may be low.
DRAWER
Apply a small amount of vegetable oil to a paper towel, and then wipe the edges of the oven racks with the paper towel.
The shiny, silver-colored racks were cleaned in a self- cleaning cycle.